Forums Technical Articles Developer Docs 中文区 UART Decoder Module Database Models Quotes & Orders EN · 中文 · 日本語 · DE · ES

LRF50H gives no data on a 5 V supply: troubleshooting checklist for the H series

Viewed 0

Frequently asked by integrators; answered by ERDI Engineering.

My LRF50H is wired to a 5 V pin on a flight controller board. The red wire is powered, the module is silent, or I get a few frames and then nothing. How do I find out what is wrong?

1 Answers

The first thing to check is the supply: the H series (LRF50H to LRF1500H) is specified for 9-36 V DC, so a 5 V pin is outside the specification. Power it from its own supply and measure the voltage at the module connector, not at the power supply. Peak current is 100 mA and average 34 mA (0.8 W average), so size the supply for the peak.

Pin order for the LRF50H: 1 red 9-36 V, 2 black GND, 3 yellow GND, 4 green TX, 5 blue RX. Module TX goes to host RX. Share ground between module and host.

Then work down the table from the docs:

  1. No bytes at all: supply, ground, baud rate (460800 by default) and TX/RX orientation. A software serial port on a small MCU will not run at 460800; use a hardware UART or set a documented lower baud rate.
  2. Frames but the checksum fails: the datasheet does not specify the TX/RX signal level for the LRF50H (it lists only the supply range). Measure the TX idle level before connecting a 3.3 V host and tell us the result; we confirm the level in writing.
  3. A few frames, then silence: brown-out on the peak current, or ranging was stopped. Re-issue start ranging 5A 0A 02 02 00 F1; stop is 5A 0A 02 00 00 F3.
  4. Readings ten times off: the H series reports centimetres, not millimetres. 5C 02 11 EC is 43.54 m on an H module.
  5. Distance stuck at 65535: that is the out-of-range marker, not a distance. Check the target and the window.

Capture 20 raw frames and send them with the supply voltage measured at the connector, as asked in https://erdilrf.com/docs/guides/field-troubleshooting/. The module detects 0.05-50 m at 90 % reflectivity but only 0.05-15 m at 10 %, so a dark surface may simply be out of range.

Sources:

ERDI Verified Answer — checked against the datasheet by ERDI Engineering.

ERDI Engineering Community is run by ERDI TECH LTD (Chengdu, China) · erdilrf.com · GitHub · Civil applications only · Questions about modules from any brand are welcome.