Forums Technical Articles Developer Docs 中文区 UART Decoder Module Database Models Quotes & Orders EN · 中文 · 日本語 · DE · ES

LR1200E4 on a Jetson Orin Nano 40-pin UART: is a level shifter needed?

Viewed 0

Frequently asked by integrators; answered by ERDI Engineering.

I want to connect an LR1200E4 to the 3.3 V UART on the 40-pin header of a Jetson Orin Nano dev kit. The module is powered from 5 V. Does TXD swing to 5 V, can I connect RXD directly, and what do I do with the SW-SHOT pin?

1 Answers

For the LR1200E4 the answer is written down (ERDI Engineering reply, 2026-10-29), and it applies to this model only:

  • TXD is a push-pull output from an internal 3.3 V LDO. With VCC at 3.3 V or 5 V it gives VOH of at least 2.9 V and VOL of at most 0.4 V, so TXD stays at 3.3 V logic even on a 5 V supply.
  • RXD needs VIH of at least 2.0 V and VIL of at most 0.8 V. The absolute maximum input is 3.6 V, so never drive RXD from a 5 V host.
  • There are no internal pull-ups or pull-downs on TXD, RXD or SW-SHOT. RXD and SW-SHOT are high-impedance floating inputs, and the equivalent load is far above 500 kohm, which meets the greater-than-50 kohm requirement of the Jetson P3768 carrier with a TXB0108 level translator.
  • Direct wiring to the 40-pin header works without a level shifter: header pin 8 (Jetson TXD) to module RXD, pin 10 (Jetson RXD) from module TXD, pins 2 or 4 for 5 V, pin 6 for GND.
  • SW-SHOT is active high and single-shot: one pulse triggers one measurement and the result comes back as one frame on TXD. A permanently high level does not give continuous ranging; use the UART continuous command for that. When you control the module over UART, tie SW-SHOT to GND (or to GND through at least 100 kohm). For hardware triggering use a 3.3 V GPIO pulse. Never leave it floating.

Serial settings are 115200 baud, 8 data bits, and the frame is the 8-byte 55 AA ... family A format.

Do not carry these numbers over to the LR1000E4, LR1500E4 or LR2000E4, and do not mix them up with the LR1200E2: each model has its own written answer, and for the models without one the datasheet does not specify the signal level, so please email us and we confirm in writing before you wire anything.

Sources:

ERDI Verified Answer — checked against the datasheet by ERDI Engineering.

ERDI Engineering Community is run by ERDI TECH LTD (Chengdu, China) · erdilrf.com · GitHub · Civil applications only · Questions about modules from any brand are welcome.