Forums Technical Articles Developer Docs 中文区 UART Decoder Module Database Models Quotes & Orders EN · 中文 · 日本語 · DE · ES

First reading with a USB-TTL adapter: the quickest way to see data from a new module

Viewed 0

Frequently asked by integrators; answered by ERDI Engineering.

I just received a module and an FTDI-style USB-TTL adapter. Nothing shows in my terminal. What is the fastest way to get a first reading, and what usually goes wrong?

1 Answers

The quickest route is the browser serial monitor linked from the ERDI docs: open it in Chrome or Edge on a desktop, pick the exact model, press Connect and you get the distance, a live chart and CSV export. Nothing is installed and nothing leaves your computer. The alternative is the Python package:

pip install erdi-lrf
erdi-lrf models
erdi-lrf --port COM3 --model LRF22VB stream --count 20      # streaming modules
erdi-lrf --port COM3 --model LRF3000A1 measure              # polled modules

Use the exact model name: the package takes baud rate, frame length and unit from it.

Then the usual causes when nothing arrives:

  1. Adapter voltage. Set the adapter to the module's logic level. Do not trust the label on a cheap adapter; measure the TX idle level. A module that runs from 5 V may still use 3.3 V signals.
  2. TX and RX not crossed. Module TX goes to adapter RX. Some datasheets label pins from the host's point of view; the pin table on the model page says which.
  3. No common ground.
  4. Wrong behaviour assumption. Family B modules (VB and H series) stream by themselves at 460800 baud, so you should see bytes immediately. Family A modules (LR, SPD1200N, LRF A1) are command/response at 115200 baud: nothing arrives until you send a command such as 55 AA 88 FF FF FF FF 84.
  5. Weak supply. Measure the supply at the connector while the module is running; a weak supply resets the module. The LRF22VB, for example, needs 3.0-3.6 V, not 5 V, while the LRF10VB needs 4.5-5.5 V.

Settings are 8 data bits, no parity, 1 stop bit. If you want to go further, read the evaluation checklist and the field-troubleshooting table in the docs. For a model that has no public protocol document, write to [email protected].

Sources:

ERDI Verified Answer — checked against the datasheet by ERDI Engineering.

ERDI Engineering Community is run by ERDI TECH LTD (Chengdu, China) · erdilrf.com · GitHub · Civil applications only · Questions about modules from any brand are welcome.