Pin definition of the 6-pin connector: 1 GND, 2 VCC, 3 I/O (reserved, leave unconnected), 4 TXD (module to host), 5 RXD (host to module), 6 SW-SHOT. Settings are 115200 baud, 8 data bits. ERDI Engineering has confirmed that the UART of this model is 3.3 V logic (a verbal confirmation; the datasheet itself does not print the level, so ask us for it in writing if your design depends on it). The ESP32 can then be connected to TXD and RXD without a level shifter, while the module is powered from its own 5 V supply.
Supply: the module takes 3.3-5 V and has an inrush current below 350 mA at start-up (power is below 0.6 W at short range, at most 1 W). Do not feed it from the 3.3 V pin of the ESP32 development board; use a regulator that can deliver the start-up current, with local bulk capacitance, and a common ground with the ESP32.
SW-SHOT (pin 6) needs care. The datasheet states "function enable (active high)" and, in the same row, "compatible with active-low control", and another page of the original manual says the pin must be pulled low. Datasheet inconsistent; this is the most common reason for a silent module. Do not leave the pin floating, and do not guess: email us your delivery batch and we confirm the required level in writing before you finish the harness.
Protocol check once powered: send 55 AA 88 FF FF FF FF 84; the reply is 55 AA 88 STA FF DIS_H DIS_L SUM. STA = 1 is valid, and the distance is the 16-bit value divided by 10. Range is 4-1,000 m, accuracy +/-1 m up to 400 m, update 3-10 Hz adaptive, and the module is not suitable for sub-4 m work, so test with a wall that is farther than that.
Dimensions in the table are 25.65 x 13.2 x 24.6 mm; the public datasheet revision prints 25.7 x 13.3, so allow clearance.
Sources:
ERDI Verified Answer — checked against the datasheet by ERDI Engineering.